Containment barriers are constructed to isolate the spread of mold spores to ceiling and fireplace water damage

Water intrusion from three sources, roof, chimney, stucco wall transition failure causing interior ceiling and fireplace water damage, dry rot, fungal growth. The key to mold control is moisture and water intrusion control. Adhering to the IICRC S520 protocals, containment barriers are constructed to isolate the spread of mold spores.

---

Water damage and mold contamination above fireplace require removal

Water damage and mold contamination above fireplace require removal. Adhering to the IICRC S520 protocals, mold remediation procedures require physical removing microbial growth including sanding, wire brushing and HEPA vacuum all surfaces prior to application of antimicrobial and anti-fungal botanical disinfectant.

---

Inspection to evaluate a roof / chimney, stucco wall water intrusion

Conducting a limited inspection to evaluate a roof, chimney, stucco wall transition water intrusion. A preliminary evaluation indicated flashing failure.

---

Defective stucco wall and chimney transition flashing

Waterproofing recommendations included saw cut 1” groove into chimney brick located at stucco wall and chimney transition. Installation of cap counter flashing waterproofing detail set in urethane with cap flange set into saw cut groove to prevent water intrusion.

---

Chimney and roof transition flashing failure

A preliminary evaluation indicated chimney and roof transition flashing failure resulting interior water damage. Waterproofing recommendations included remove and replace existing flashings.

---

Removal of existing stucco wall, roof, chimney flashing transition

GWaterproofing recommendations included removal of existing stucco wall, roof, chimney flashing transitions due to failure.

---

Installation of bonderized flashings to stucco wall, roof, and chimney transitions

Corrections include installation of bonderized flashings to stucco wall,roof, and chimney transitions. Sheet applied membrane creating a monolithic surface, protecting from wind driven rain intrusion.

---

Stucco application to stucco wall, chimney, and roof transition

Corrections include sloped cricket chimney flashing, stucco counter flashing and wire mesh for stucco application.

---

Tamko roofing underlayment membrane installation protecting from wind driven rain water intrusion

Restoration process includes stucco application to stucco wall transition, Tamko underlayment membrane protecting from wind driven rain intrusion. We provide the equipment, experience, and knowledge to identify and correct building failures.

---

Section of drywall removed in an effort to identify the leak source

Roof Leaks / Water Damage / Mold Remediation Solutions Conducting a limited inspection to evaluate the water intrusion located at wall mounted heater. Section of drywall removed in an effort to identify the leak source.

---

Section of drywall removed to identify source of water intrusion

The source of water intrusion must be identified and eliminated to prevent mold contamination from recurring. The key to mold control is moisture control.

---

Containment barriers constructed with plastic to contain spread of mold spores

Adhering to the IICRC S 520 protocals, containment barriers are constructed with plastic to contain the spread of mold spores. Negative pressurization with HEPA filtration removes air born mold spores during remediation process.

---

Roof leak identified as source of water intrusion and mold contamination conditions

Section of ceiling drywall removed in an effort to identify the leak source. Long term roof leak identified as source of water intrusion and mold contamination conditions.

---

Replacing roof plywood substrate wood rot and torch down roofing membrane

Repair recommendations included roof plywood substrate wood rot replacement and torch down roofing membrane replacement.

---

Remediation procedures include physically removing mold

The IICRC S 520 Mold Remediation Standard states that “Attempts to kill or encapsulate mold are inadequate remediation measures” Instead, the S 520 Standard highly recommends that remediation procedures include physically removing mold through sanding, wire brushing and HEPA vacuuming all surfaces.

---

Application of “BENEFECT” anti-fungal disinfectant to structural framing

Adhering to the IICRC S 520 protocals, application of “BENEFECT” anti-microbial and antifungal disinfectant to structural framing. “BENEFECT” is classified under the EPA’s highest safety rating category allowed by law. Safe botanical disinfectant for mold remediation killing over 99.99% fungi, bacteria and other organisms.

---

Application of “BENEFECT” anti-microbial botanical disinfectant to structural framing

Application of “BENEFECT” anti-microbial and anti-fungal botanical disinfectant to structural framing. EPA registered botanical disinfectant. Safe green mold remediation technologies

---

Replacement to water damaged roofing plywood substrate completed

Replacement to water damaged roofing plywood substrate completed, including mold remediation.

---

Restoration includes replacing mold contaminated insulation replacement

Restoration includes replacing mold contaminated insulation replacement

---

Restoration includes wall mounted heater replacement and insulation

Restoration includes wall mounted heater replacement and insulation.

---

Restoration includes drywall, plastering. and orange peel texture to match existing

Restoration includes drywall, plastering, and orange peel texture to match existing.

---

Containment barriers in place during restoration process

Restoration process completed with containment barriers to also control restoration dust. We document the water intrusion and provide you with a report and estimate that clearly details the extent of damages.

---

Locations We Serve:
Los Angeles | Santa Barbara | Ventura County | Orange County| Santa Monica | Pasadena | Woodland Hills | Thousand Oaks | Malibu | Encino | Calabasas | Hidden Hills | Agoura Hills | Burbank | Culver City | Glendale | Manhattan Beach | Palos Verdes Estates | Rolling Hills | Redondo Beach | Rolling Hills Estate | Santa Clarita | South Pasadena | West Hollywood | Westlake Village | Marina del Rey | Beverly Hills | Topanga